Potassium chloride: shale inhibition
Reactive shales contain clays that take up water, swell and disperse. That leads to tight hole, bit balling and wellbore instability. Potassium ions are small enough to fit into the clay structure and reduce swelling, which is why KCl is the classic inhibitive salt in water-based muds.
KCl is usually run at a few percent up to about 10% by weight, together with polymers:
- PHPA to encapsulate cuttings
- Xanthan gum for viscosity
- Starch for fluid-loss control
Potassium hydroxide can be used for pH control, to add potassium rather than sodium.
Sodium chloride: drilling salt sections
When a well drills through rock salt, fresh water dissolves the formation and creates washouts. Saturating the mud with sodium chloride stops it dissolving more salt, keeping the hole in gauge. Salt-saturated muds also reduce the risk of gas hydrates in some operations.
Choosing between them, or using both
- Reactive shale, no salt section: a KCl/polymer system is the usual starting point.
- Massive salt: a salt-saturated NaCl system.
- Both: KCl and NaCl can be combined, with the programme setting the ratio.
Other considerations
- Disposal. High-chloride fluids face discharge and disposal limits in many areas.
- Monitoring. Potassium and chloride concentrations need regular checks, because they fall as salt is used up.
- Cost. KCl costs more per tonne than NaCl, so concentration is worth optimising.
General guidance only. Always follow your engineering programme, the product safety data sheet and the current edition of any standard referred to.