Home / Resources / Article

Calcium chloride 77% flakes vs 94–97% anhydrous: which grade to buy

Both grades are calcium chloride. The difference is how much water is already in the product, and that changes how much you need, what you pay per kg of active salt, and how much heat you get when mixing.

The short answer

Calcium chloride is sold in two main commercial grades. The 77–80% grade, usually as flakes, is largely calcium chloride dihydrate: roughly a fifth of every bag is water. The 94–97% grade, usually as granules or powder, is anhydrous. The salt does the same job either way, so the right choice comes down to cost per kilogram of actual calcium chloride, freight, handling and the heat released when mixing.

What the percentage means

The percentage is the assay: the share of calcium chloride by weight. One tonne of 77% product contains about 770 kg of calcium chloride. One tonne of 96% product contains about 960 kg.

Converting between the grades

To replace the 94–97% grade with the 77% grade, multiply the quantity by the ratio of the assays. For a 96% product, that is 96 ÷ 77 ≈ 1.25.

You need this much CaCl₂Using 96% gradeUsing 77% grade
1,000 kgabout 1,040 kgabout 1,300 kg
10 tonnesabout 10.4 tonnesabout 13.0 tonnes

To compare prices fairly, divide the price per tonne by the assay. That gives the price per tonne of calcium chloride you are actually buying. Then add freight: with the lower grade you are also transporting the water.

Heat when dissolving

Calcium chloride releases heat as it dissolves, and the anhydrous grade releases considerably more than the flakes. When building brine, add the salt gradually to water that is already circulating, not water onto a pile of salt. Use the protective equipment set out in the safety data sheet.

Where each grade is used

  • Completion and workover brines up to about 11.6 ppg (1.39 SG).
  • The water phase of oil-based muds, to control water activity and protect shales.
  • Cement acceleration, at low concentrations.
  • Industry, for de-icing, dust control and processing.

The anhydrous grade is often preferred where freight and handling dominate, or where heavy brine has to be mixed quickly. The flake grade is often cheaper per bag and dissolves with less heat.

Storage

Both grades absorb moisture from the air and will cake or even liquefy if bags are damaged. Keep bags sealed, off the floor and under cover, and use the oldest stock first.

General guidance only. Always follow your engineering programme, the product safety data sheet and the current edition of any standard referred to.

More technical notes