Home / Resources / Article

Choosing a completion brine: density, crystallisation and compatibility

Clear brines control well pressure without solids that can damage the reservoir. Choosing one means balancing density, crystallisation temperature, compatibility with the formation, and cost.

What a completion brine does

A completion or workover brine is a solids-free fluid that holds back formation pressure while the well is completed or worked over. Because it carries no solids, it does not plug the reservoir the way a drilling mud can.

Density: which salt reaches which weight

Each single-salt brine has a maximum density, reached when it is close to saturation. Approximate values at about 21 °C (70 °F):

SaltApprox. maximum density
Potassium chloride9.7 ppg (1.16 SG)
Sodium chloride10.0 ppg (1.20 SG)
Calcium chloride11.6 ppg (1.39 SG)
Calcium bromide15.3 ppg (1.83 SG)

Blends of calcium chloride and calcium bromide cover the range in between. Zinc bromide blends go higher still, but bring extra cost and handling considerations. Always plan with a margin above the density you need.

Crystallisation temperature

A brine close to saturation can start to crystallise if it cools, for example at surface on a cold night or at the seabed. Crystals block lines and change the density. Choose a formulation whose true crystallisation temperature is safely below the lowest temperature the brine will see.

Compatibility with the formation

  • Clays. Fresh water can swell reservoir clays. Potassium chloride or ammonium chloride helps stabilise them.
  • Formation water. Calcium brines can form scale if they meet formation water rich in sulphate or bicarbonate. Lab compatibility tests show whether this is a risk.
  • Corrosion. Oxygen in brine drives corrosion. Oxygen scavengers such as sodium sulphite are commonly added.

Clarity

Brines are filtered to remove fine solids before use. Starting with clean, consistent salt makes filtration faster and cheaper.

Cost and reuse

Heavier brines cost much more per barrel. Use the lightest brine that gives a safe margin, and plan to recover and reuse brine where possible.

General guidance only. Always follow your engineering programme, the product safety data sheet and the current edition of any standard referred to.

More technical notes