Home / Resources / Article

Drilling-grade barite: what API 13A asks for and how to check it

Barite is the standard material for raising mud weight. API Specification 13A sets the properties drilling-grade barite must meet. Here is what each one means for your mud, and how to check a batch.

Why barite

Barite is natural barium sulphate. It is dense, chemically inert in drilling fluids, and widely available, which makes it the default material for increasing mud weight to control formation pressure.

The main API 13A requirements

API Specification 13A covers drilling fluid materials, including barite. For the standard barite grade, the key requirements include:

PropertyRequirementWhy it matters
Density4.20 g/cm³ minimumHigher density means fewer solids are needed for the same mud weight.
Water-soluble alkaline earth metals, as calcium250 mg/kg maximumSoluble calcium can contaminate water-based muds.
Residue larger than 75 µm3.0% by mass maximumCoarse particles settle out and wear equipment.
Particles smaller than 6 µm30% by mass maximumToo many fines raise viscosity.

The standard also includes a lower-density grade, often called barite 4.1, with a minimum density of 4.10 g/cm³. Always check requirements against the current edition of API 13A and your own mud programme.

How to check a batch

  • Ask for a certificate of analysis for the lot you are buying, showing the properties above.
  • Spot-check density in the lab with a Le Chatelier flask or a gas pycnometer.
  • Wet-sieve a sample at 75 µm to confirm the coarse fraction.
  • Watch your mud after additions. A rise in viscosity or signs of barite sag can point to a particle size problem.

Bulk or bags

For rigs with bulk silos, bulk delivery is fastest and avoids bag handling. For smaller jobs or sites without silos, jumbo bags are simpler. Barite must be kept dry in both cases: moisture causes bridging in silos and lumps in the mud.

How much barite do you need?

Use our barite weight-up calculator to estimate the quantity needed to raise a given volume of mud to a target weight.

General guidance only. Always follow your engineering programme, the product safety data sheet and the current edition of any standard referred to.

More technical notes