Home / Resources / Article

H₂S in drilling fluids: how zinc-based scavengers work

Hydrogen sulphide is deadly at low concentrations. Drilling fluids are protected in two ways: high pH holds sulphide in solution, and zinc-based scavengers remove it permanently.

Why H₂S needs special treatment

Hydrogen sulphide (H₂S) can enter the mud from sour formations. It is toxic at very low concentrations, corrodes and embrittles steel, and can be released at surface from the mud. Drilling programmes in sour areas plan both mud treatment and personnel protection.

Line of defence 1: high pH

At high pH, dissolved sulphide stays in the mud as sulphide and bisulphide ions instead of escaping as H₂S gas. Alkalinity is usually maintained with caustic soda or lime.

This protection is reversible. If pH drops, H₂S can be released again.

Line of defence 2: zinc-based scavengers

Zinc compounds such as zinc carbonate and zinc oxide react with sulphides to form zinc sulphide. Zinc sulphide is insoluble, so the sulphide is removed from the mud permanently. Scavenger is often kept in the system as a pre-treatment before sour zones are drilled.

The choice of scavenger and the treatment level depend on the mud system and the expected H₂S. They should be set by the mud programme.

Monitoring

Sulphide in the mud filtrate is measured with the Garrett Gas Train test described in API recommended practice for field testing of drilling fluids. pH and alkalinity are checked alongside it.

Safety comes first

Chemical treatment does not replace H₂S detection, breathing apparatus, training and an emergency response plan.

General guidance only. Always follow your engineering programme, the product safety data sheet and the current edition of any standard referred to.

More technical notes